* Setting the most suitable temperature
Tool low temperature will waste electricity and have an impact on plant growth.
When the indoor temperature is adjusted to 26-27 ℃, the cooling load can be reduced by more than 8%.
When the setting temperature is 2 ℃ higher, it can achieve 20% power saving.
When heating, the setting temperature is 2 ℃ lower, it can also save 10% power.
* Avoid the greenhouse damage as far as possible
In case that there is damage in the greenhouse, the grower should repair it promptly.
*Smart Greenhouse System can be used with the greenhouse shading system
In hot summer, avoiding direct sunlight and reducing the cooling pressure of the system can save about 5% power.
* The Indoor Unit need to connect with the flexbile duct(Eg Fabric Duct)
By reasonable layout and installation in the greenhouse(especialy for large space), the temperature and air can be evenly distributed.
*Suitable installation position
Avoid the direct sunlight to the unit especially Outdoor Unit.
When there is no shadow, the Outdoor Unit should be covered with a shade, which is also conducive to extending the service life.
Avoid obstacle in front of the air outlet,or it leads to increased power consumption.
* Correct connection between Indoor Unit and Outdoor Unit
Make the connection pipes between the Indoor and Outdoor Unit as short as possible and not bend.
Then the cooling effect will be better and electricity-saving.
* Reasonable ventilation time
When using the Smart Greenhouse System, do not open windows and doors frequently to reduce the hot air entry.
Open the ventilating windows as little as possible.
When do not open new air doors, it can save 5-8% of the electricity.
*Regular maintenance and maintenance
Clean and maintain the Smart Greenhouse System regularly at regular intervals,specially the air filter.
Too much dust will clog the mesh and make the system more laborious.
As a result, the power consumption of the system increases.
So do a good job of daily maintenance, usually more than 1 month cleaning once.
* Turn off the Smart Greenhouse System in advance.
Turn off the Smart Greenhouse System ten minutes in advance when it is not needed to save electricity.
* Install the Indoor Unit at the most reasonable height.
Because the cold air drops, it always sinks in the lower part of the greenhouse.
The lower the Indoor Unit is installed, the smaller the space for Cooling is, the more energy-saving it will be.
*Avoid frequent switch-on and start-up of Smart Greenhouse system.
* It can save about 15%~30%(specially for large greenhouse) when used with Energy-Saver.
* Reasonable use of system’s timing setting function.
